Material-efficient Cu wire-based 3D printing technology

Area Acceleration (D2) Segment Upscaling (D2.2) Duration 2019/01/01-2021/12/31

Global Conference on 3D Printing and Additive Manufacturing 14 grudnia 2022

Global Conference on 3D Printing and Additive ManufacturingGlobal Conference on 3D Printing and Additive Manufacturing

Date: 10-11 November 2022

Place: Valencia, Spain

This conference focuses on 3D Printing and Additive Manufacturing so it was a perfect place to present two posters. They were about: WAAM parametres optimisation for non-commercial CuAl-based alloys and 3D printing technology for marine propeller prototype.

Project Partners

Łukasiewicz Research Network - Institute of Non-Ferrous Metals

  • Development of the Cu-based alloys
  • Development of production technology of feedstock materials for WAAM
  • Wire arc additive manufacturing at laboratory scale
  • Materials investigations

Ghent University

  • Corrosion-fatigue investigations
  • Tests of the prototypes in seawater environment
  • Educational activities

Italian National Agency for New Technologies, Energy and Sustainable Economic Development

  • Material investigations
  • Mechanical proporties

Gefertec GmbH

  • Development of the production process parameters by means of 3DMP technology
  • Implementation of the results of the project (end user)
  • Manufacturing of the new products

Tecnalia Research and Innovation

  • Erosion tests
  • Non-destructive tests

Supported by

2019 © Material-efficient Cu wire-based 3D printing technology | All rights reserved
Agencja Interaktywna ITOWN - profesjonalne strony www